Details – AF Consistency
On this page
The Details tab (FoCal Pro) shows the full results of the test. If the test has more than one data set (for example phase-detect and live view autofocus, or defocus from both directions), most figures are shown for each data set.

Test ID
A unique identifier for this test. Quote it when you refer to the test, for example when you contact Reikan support.
Measurement Count
The number of measurements in the test. With the default settings this is the same as the number of shots. With Both selected for Autofocus Mode and Defocus Direction, each point can have up to four measurements (phase detect and live view, each defocused near and far).
Shot Count
The number of images the camera captured for the test.
Consistency of Focus
How close the sharpness of the shots is to each other. 100% would mean every shot was exactly as sharp as the others.
A good camera and lens typically scores around 98%. If the light is steady and the setup solid, results repeatedly well below that may point to a problem with the lens or the autofocus.
The Compare and Scores tabs show how your result compares with other FoCal users of the same camera and lens (FoCal Comparison Data). Use them to judge whether the result is normal for this lens.
Astigmatism Factor
How the sharpness in the horizontal direction compares with the vertical direction, shown as the median across the test, for example "4.0%". A value away from 0% can mean the lens has a misaligned or decentred element.
- 0%: horizontal and vertical sharpness are equal.
- Above 0%: the horizontal direction is sharper. For example, if it is 10% sharper, the value is +10%.
- Below 0%: the vertical direction is sharper. For example, if it is 5% sharper, the value is -5%.
See Astigmatism Factor – AF Consistency.
Red-Blue Ratio
How the sharpness of the red channel compares with the blue channel, shown as the median across the test. Large values show the colours are focused at different points (chromatic aberration), which appears as colour fringing.
- 0%: red and blue are equally sharp.
- Above 0%: red is sharper. For example, if red is 10% sharper, the value is +10%.
- Below 0%: blue is sharper. For example, if blue is 5% sharper, the value is -5%.
See Red-Blue Ratio – AF Consistency.
Red:Green and Blue:Green
The sharpness of the red and blue channels as a percentage of the green channel, shown as the median across the test. 100% means the same sharpness as green. See Red-Blue Quality – AF Consistency.
AF/Capture Time
How long the camera took to focus and take each shot. Reading the image from the sensor takes a short, fixed time, so this mostly reflects how quickly the autofocus and lens work. It depends on the lens and on the distance to the target.
Spectral Info
The mix of red, green and blue in the light used for the test, as the camera recorded it.
In JPEG mode the camera's own processing has a strong effect on these figures. In Raw mode FoCal corrects for the camera's colour filters to estimate the real light. The accuracy depends on how close the colour temperature in FoCal's settings is to the real light.
Use this as a check for roughly white light, with all three values around 33%. If one value is far from 33% (more than 50% or less than 10%), the results are unlikely to represent normal shooting conditions.
Camera Info
The camera used for the test, including its temperature if the camera reports it.
Lens Info
The lens used for the test, including the focal length if known.
Target Distance
The distance between the camera and the FoCal target, either calculated by FoCal from the target or reported by the camera.
Distances reported by the camera can be quite inaccurate. The Target Width setting in FoCal's settings also affects the calculated distance.
Target Info
The target checks used for this test.
- Target Validation confirms the target is in the right place and orientation, and that nothing changed significantly between shots.
- Target Optimisation makes small adjustments to the analysis position to allow for slight movement of the image, for example from lens defects.