Canon – User Assisted Mode operation
On this page
This page shows how to use User Assisted Mode on Canon cameras. Menu names and positions vary between camera models.
Before the test
Set the camera up before you start a calibration, so you need to do as little as possible during the test.
Press the Menu button and go to the AF5 menu (on some cameras, a different AF menu page). Select AF Microadjustment with the dial or the joystick:

Press SET. You'll see a screen like the one below (what it shows depends on the lens). Select Adjust by lens:

The camera is now ready for the test.
During the test
Be careful not to move the camera when you change its settings. FoCal copes with small movements of the image, but large movements can make the results inaccurate.
When FoCal needs you to change the setting, it shows a message like this. If voice prompts are on, it also tells you the value to set:

For a zoom lens, FoCal tells you whether to set the wide end, the telephoto end or both. A prime lens has only one setting.
Go to the camera and press the Menu button. If you followed the setup steps above, the menu opens here:

Press SET on AF Microadjustment:

Then press INFO:

This example shows a zoom lens on the EOS 5D Mark III. Choose W (wide end) or T (telephoto end), as the FoCal message says, and press SET:

Dial in the value FoCal asked for, then press SET again.
Then use the camera hotkey (see below), or click Continue on the FoCal message (or press Return), and the test continues.
Camera Hotkey
The camera hotkey tells FoCal you've made the change, without going back to the computer. See: